IT Development - Datalogger Service Software for DS1615 Reference Guide

Connect your device to a RS232 port of your PC.
Power your device on
1. Launch the program
2. This software automatically detects available RS232 communication ports. You will be prompted at first startup for selecting the device your datalogger is connected to.
Menus
1. File Open
  Save, Save As…
2. Memory
  Load All
  Loads entire chip memory into your PC. This take about 1 minute long.
  Load Status
  Loads chip status registers, in order to read his configuration. This operation is very fast.
  Load Histogram
  Loads statistical datas from the chip.
  Load Data Log
  Loads entiere log memory.
  Clear Alarm flags
  Clear All
  Clear ALL DATA from the chip
  Datalog RollOver
  If checked, allows the chip to rollover when last sample is recorded. If unchecked, the sampling will be stopped.
3. Actions
  Start logging process now
  Start logging process (delayed)
  Stop logging process
  Enable Sart button
  Allows start logging by pressing an external button. This button must be connected to the chip.
  Specification test
  Measure current temperature
  Syncronize RTC with PC
  Set chip’s internal clock to the PC time
  Storage mode
  Disables chip internal oscillator when external power is off (this saves battery)
4. Settings
  Communication device
  Available devices are automatically detected by software
  Time format
  12h/24h
  Temperature unit
  [PENDING] Centigrade/Fahrenheit/Kelvin

IT Development software